CLsqFit:Using CLsqFit with Image Pixels

Using CLsqFit with Image Pixels

Often, the data you need to fit come from an image. The example below describes how to efficiently fit the image values for a displayed image set. The key feature of this particular application is the CImage:GetVal method which fetches the pixel value from an image. This value is added directly to the least squares sample using CLsqFit:AddPt . This assumes the image has a numeric pixel type (real, integer, etc.) with 1 channel. If the image is of the multi-channel (e.g., RGB) type, then the only change needed is to use GetValStr instead of GetVal . GetValStr returns all channel values as a comma-separated string which is also accepted by the AddPt method. Also note that the script uses CRect: Round to convert the fractional pixel locations of the cursor rectangle into exact integer values which correspond to the value at the center of each pixel.

Example

The following script fits a 2x2 polynomial "warped plane" to pixels inside the cursor rectangle on the images of a displayed image set. Since it works with a displayed image, you would place the target image window on top and run the script using[!] on the main menu (not the script editor window). The script first creates a CLsqFit object and sets the fit parameters. The script next attaches the top-most window, checks that it is an image window, and then loads the coordinates of its image cursor. Images are processed inside a loop that fits each member of the image set independently. The point sample is reset and then each point inside the image cursor rectangle is added to the CLsqFit point sample. After that, the fit is computed. If successful, you would insert code that does something with the fit—for example, you might store results in a table for later use or evaluate the fit and replace pixels having high residuals.

L = new_lsqfit()	-- create the least squares fitting object
L:SetNumCoefs( {2,2} )	-- fit a 2,2 polynomial ("warped plane")
L:DoRejection()	-- enable data rejection with standard parameters
L:SetRejSigmaLow("10,4,3")	-- open up the lower sigma because outliers are positive

-- open and display images until the user clicks Cancel in the Open dialog
V = CImageView:Attach()	-- attach the top-most window that is an image window
Assert( V and V:Count() > 0, "no images")

R = V:GetCursorRect()	-- Create a CRect for the cursor rectangle
if R:Width() * R:Height() > 1000 then	-- check the size. don't want too many points
Exit("Too many points in the rect\n" )
end
R:Round()	-- round to exact integers for the pixel coords

for i = 1, V:Count() do	-- loop over each image
I = V:GetImage(i)	-- create a CImage for the i-th displayed image

L:ResetPoints()	-- clear out points from the prior image

-- create a sample of points for fitting
for j = R.ymin, R.ymax do
for i = R.xmin, R.xmax do
L:AddPt( { i, j }, I:GetVal(i,j) )	-- combine (x,y) coords in in a table ()
end
end	-- end of pixel adding loop

bSuccess = L:Fit()	-- do the fit and check for success
if bSuccess then
-- do something with fit results
end
end	-- end of image loop

Example

Related Topics