The Edit > Undo command in the Edit menu.
The Undo button on the
Image Bar.
Some dialog windows also have Undo buttons as a convenience.
Undo
Mira provides Undo capability through several implementations of the Undo command:
The Edit > Undo command in the Edit menu.
The Undo button on the
Image Bar.
Some dialog windows also have Undo buttons as a convenience.
This command also uses the standard keyboard accelerator Ctrl+Z.
For Image Windows, Undo has
two options; they can restore the previous state of one
image or the entire image set. When the Image Window
contains an image set, you control the operation using the
(Process Image Set) button.
With the button pressed, Undo applies to the entire image set.
With the button released, Undo applies only to the current image.
Undoing an image set is especially powerful. For
example, you might register a set of 30 images, then use Combine Image Set to
average them into a single, high signal-to-noise master image. Upon
inspecting the new master image you might find that the
registration was not as good as you had thought. Since Combine Image Set
places the new image into a new window, the Image Set that you
registered still exists (unless you closed it). To reverse the
registration and try again, be sure is pressed, then execute Undo (you can
determine the button state by reading the pop-up tooltip for the
button). In this example, Undo would restore all 30 images to their
pre-registered state.
Mira Pro x64 8.67 User's Guide, Copyright Ⓒ 2023 Mirametrics, Inc.
All Rights Reserved.