Open this dialog by clicking 
on the Interactive Repair Toolbar
Pixel Repair Properties
The Pixel Repair Properties dialog is used to configure the Interactive Repair command. Here you can change the size of the neighborhood used to generate a new pixel value and also tell it whether you are zapping hot pixels or cold defects.
Open this dialog by clicking on the Interactive Repair Toolbar
Interactive Pixel Repair Properties
|
Width |
The width of the region used to sample "good" pixels. |
|
Height |
The height of the region used to sample "good" pixels. |
|
Defect Type |
The intensity of the defect relative to its surroundings. |
The sample region affects the size of the artefact you can repair with the tool. For small artefacts like isolated pixels, choose a small sample region. If you try to work away at the edges of a large defect it is best to use a larger sample region to "pull in" good comparison pixels from far away from the pixel of interest.